How To Clean Soap Scum From Bathroom Sink

Download Article

Download Article

No affair how oftentimes you lot make clean your bathroom, soap scum is going to build upwards on the tile in your shower and/or bathtub from fourth dimension to time. Unfortunately, you lot ordinarily tin can't scrub it off with conventional lather and water. Instead, you must use specific cleansers that cut through the thick scum then it will loosen enough to scrub off. Commercial tile and bathroom cleaners work well for removing soap scum, but you can also make your own with dish detergent and vinegar. If you lot prefer all-natural cleaning products, a paste made from baking soda and vinegar can also exercise the flim-flam. The primal to using any of the cleansers to remove soap scum is patience, though -- you lot must leave them on the tile for at least a few minutes then they have fourth dimension to break downward the lather scum.

1. 1

   Spray the tile with a targeted tile cleaner. A commercial bath or tile cleaner is often the easiest manner to get rid of lather scum because it is formulated specifically to get rid of the stubborn residue. Apply a generous coat of the cleaner to the muddied tile co-ordinate to the bottle's instructions.^[1]

   • Tile or bathroom cleanser typically comes in two formulas: a liquid or foam spray. A liquid spray is effective on horizontal tile surfaces where you don't take to worry near it dripping.The foam is often easier to use on tile walls because it stays in place without dripping off.
   • Always read the instructions on a commercial tile or bath cleaner earlier using information technology on any tile.
   • Before applying the cleaner all over the tile, test information technology in a small, inconspicuous area to ensure that it won't harm the tile.

2. 2

   Allow the cleaner to sit on the tile for several minutes. Once y'all utilize the tile cleaner to your tiled surfaces, y'all must permit it to sit down for approximately 3 to 5 minutes. That gives the cleaner time to cut through the soap scum and residue so you can easily remove information technology.^[2]

   • Some cleaners may need to be left on longer than 5 minutes. Consult the bottle's instructions to determine the proper corporeality of time.

   Advertising

3. 3

   Wet a sponge and wipe downwardly the tile. Later the cleaner has sabbatum on the tile for several minutes, run a sponge under warm h2o. Use it to carefully wipe down the tile and remove the soap scum and cleaner residue.^[three]

   • Make sure to use a non-abrasive sponge or yous may scratch the tile. You tin substitute a damp cloth for the sponge if you adopt.
   • If there are areas of the tile where the soap scum is particularly stubborn, yous may need to utilize a soft scrub castor to remove the residue. Be careful not to scrub as well hard, though, or you may scratch the tile.

4. 4

   Rinse the tile with warm h2o. When you've wiped away all of the soap scum and cleanser residual with the sponge, make full a spray bottle with warm water. Spray the tile with the water to rinse the surface until information technology's make clean.^[4]

   • If you don't have a spray canteen, you can moisture a cloth with warm water and employ it to rinse the tile.

5. 5

   Dry out the tile. To keep the tile from developing more soap scum or mildew, it'southward important to dry it completely. Use a squeegee or towel to thoroughly dry the entire surface.^[5]

   Advertizement

1. i

   Measure equal parts of vinegar and dish soap. To make bootleg soap scum cleaner, you'll need equal parts of white vinegar and dish lather. You can make as little or as much of the cleaner as you'd like, and then suit the amounts accordingly to accept 1 part of each.^[6]

   • If you want to brand enough of the cleaner to use repeatedly, it's best to measure betwixt i and 2 cups (237 to 473 ml) of both the vinegar and dish detergent.

2. 2

   Warm the vinegar in the microwave. In one case you've measured out the vinegar and dish soap, transfer the vinegar to a microwave-safe bowl. Estrus information technology in the microwave for 30 seconds to i infinitesimal or until it is hot but non boiling.^[7]

   • Heating the vinegar makes it easier to blend information technology with the thick dish soap.

3. 3

   Combine the vinegar and soap in a spray bottle and shake information technology to mix. After you've heated the vinegar, pour it into a spray bottle. Add an equal corporeality of the dish soap, and secure the lid on the canteen. Shake it well to mix the two.^[8]

   • Exam the spray after you've mixed information technology. If it's too thick to spray, you can mix in a little bit of warm, distilled water to sparse it out.

4. 4

   Spray the mixture over the tile and let it sit. When you're ready to use the cleaner, spray a generous amount over the affected tile. Allow the spray to sit down on the tile for at least 30 minutes so it has time to cut through the soap scum.^[ix]

   • If the tile has a particularly thick layer of soap scum, you may want to leave the spray on the surface for an hour or longer.

5. 5

   Wipe the tile downwardly with a damp sponge and rinse it clean. After you lot've permit the cleaner sit down on the tile for a half hr or longer, use a damp sponge to wipe the soap scum and residue abroad. Side by side, spray the expanse with warm water to rinse it completely clean.^[10]

   • If the lather scum isn't wiping away on the sponge, you can use a soft scrub brush to piece of work on the stubborn areas. Scrub lightly, though, to avert scratching the tile.
   • If you don't accept a spray bottle to rinse the tile, wet a clean fabric or rag with warm water to rinse it.

6. 6

   Dry the tile. One time the tile is rinsed clean, employ a clean towel or rag to wipe down the surface so it is completely dry out. Go along the bottle of cleanser with the balance of your cleaning supplies, and use anytime that you lot notice soap scum buildup.^[11]

   • The homemade soap scum cleaner should stay effective for vi months to one year.

   Advertisement

1. 1

   Mix the blistering soda and vinegar. If yous prefer an all-natural tile cleaner, add i cup of baking soda (180 one thousand) to a bowl. Drizzle in just plenty white vinegar to create a thick paste.^[12]

   • Information technology'due south normal for the mixture to fizz when you combine the ingredients.

2. 2

   Use the mixture to the tile and permit information technology sit. Once the baking soda and vinegar mixture stops fizzing, use it the muddied tile with a damp sponge. Let the mixture to sit on the surface for at to the lowest degree 15 minutes and then it has fourth dimension to suspension downwardly the soap scum.^[13]

   • You may want to get out the blistering soda paste on the tile for upwards to a half 60 minutes if the soap scum is particularly thick.

3. 3

   Wipe the mixture off with a sponge and rinse the tile off. After you've allowed the baking soda paste to sit on the tile for at least 15 minutes, moisture a clean, not-abrasive sponge and wipe information technology away. Side by side, utilize a spray canteen filled with warm water to thoroughly rinse the tile so it's completely clean.^[fourteen]

   • If there are some areas where the soap scum hasn't come off, you lot can scrub them with a soft-bristled brush.

4. 4

   Dry the tile. When the tile is completely make clean, use a make clean towel or fabric to wipe down the surface. Information technology's important to dry the tile completely if y'all want to keep the surface free of lather scum and mildew.^[15]

   Advertising

Add New Question

• Question

  How practice y'all remove heavy lather scum?

  

  Heather Isenberg is a dwelling cleaning good and the Possessor of The Tidy Maiden, a residential and commercial cleaning service company serving the San Jose and Los Angeles, California regions. Heather's concern The Tidy Maiden and Heather'south book The Automatic Bosslady were recently featured on CBS.

  

  House Cleaning Professional

  Expert Answer

• Question

  Can you utilise these on drinking glass shower doors?

  

  Both the vinegar and detergent mixture and the vinegar and blistering soda mixture are safe to use on soap scum on drinking glass shower doors. If you're using a commercial bath cleaner, make sure that the label says it is safety to use on drinking glass.

Ask a Question

200 characters left

Include your email address to become a message when this question is answered.

Submit

Advertisement

• Avert hard water stains and soap scum stains by wiping down your shower with a squeegee or hand towel afterward each use.

• No affair what type of cleanser you're using to remove the lather scum, make sure that your bath is properly ventilated before you showtime cleaning. Open up a window and/or turn on a fan and then the fumes don't carp y'all.

Advertisement

Things You'll Demand

• Commercial tile or bathroom cleaner
• Sponge
• Spray bottle with warm water
• Squeegee or towel

• Measuring cup
• Microwave-condom bowl
• Spray bottle
• Sponge
• Towel or rag

• Basin
• Spoon
• 2 sponges
• Towel or material

About This Article

Article Summary X

To remove soap scum from tile, start by mixing equal parts white vinegar and liquid dish soap. You tin can also make a paste using baking soda and white vinegar. In one case y'all've made your cleaning mixture, use information technology to the tile you want to make clean and let it sit for 30 minutes. Later 30 minutes, wipe down the tile with a damp sponge and rinse the tile with clean water. To acquire how to remove soap scum from tile using commercial products, continue reading!

Did this summary help you?

Thank you to all authors for creating a page that has been read 268,388 times.

Did this article assist you lot?

Source: https://www.wikihow.com/Remove-Soap-Scum-from-Tile

Posted by: carterseethe.blogspot.com

Share this post